About joey

joey · 08-21-2006

When trying to send an e-mail from the SMTP server on the DMZ to the mail server on the inside network, the mail is not delivered. Is this due to the fact that the firewall can not route the message to the mail server? If so how can I get around this...

joey · 08-21-2006

The host with ip address 172.17.2.1 can not connect to the internet nor can I connect to it remotely using PCAnywhere. If the host uses any other ip address on the inside network that is not statically assigned it can get to the internet with no prob...

joey · 04-27-2006

I have created a new vlan on the switch and it always shows "VLAN2 is administratively down". I entered the "no shut" command and it still shows "VLAN2 is administratively down"....

joey · 08-30-2006

Hello Sundar are you there?

joey · 08-29-2006

Thanks Sundar,I tried the configuration changes that you suggested. However I think the correct address for the host on the dmz should have been 172.17.17.111 and i think the conduit command should have the host addresses reversed. I tried it both wa...

joey · 08-29-2006

Hello,I tried telneting on port 25 to 199.199.199.70 from 172.17.17.111 and that did not work. The host ( 172.17.17.111) is trying to route mail to the mail server (199.199.199.70).Also here is the config file.

joey · 08-28-2006

Are there any more suggestions for my problem?Thanks,Joey

joey · 08-23-2006

Thanks, I did issue a clear xlate. I will try to use debug and see if I see any output. How can I remove the config file?

Member Since	‎04-27-2006 01:27 PM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	19

User Statistics

User Activity

Connecting to the mail server from the DMZ

Static commands

Managing a Cisco 2924

Re: Connecting to the mail server from the DMZ

Re: Connecting to the mail server from the DMZ

Re: Connecting to the mail server from the DMZ

Re: Connecting to the mail server from the DMZ

Re: Static commands