Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
We have around 13 Cisco SG-300 based switches, most of which work fine, however we have a problem with 2 of them.
When these two switches are rebooted they lose the configuration on a few ports, they get reset to a config they were on many m...
Hi all. Brief descript ion of our network:-2 x 3750's stacked at coreLinksys 2024, 2048, cisco 200 and 300 series access switches.LWAPP 2112 for wireless.We have multiple VLANs configured and the 3750's are doing the routing.3750's info:-Version 12.2...
Hi all. Brief descript ion of our network:-2 x 3750's stacked at coreLinksys 2024, 2048, cisco 200 and 300 series access switches.LWAPP 2112 for wireless.We have multiple VLANs configured and the 3750's are doing the routing.3750's info:-Version 12.2...
Hi Michal,
Yes, smartport is enabled on these switches (in fact all of out SG300 switches).
we don't have a voice vlan so that's ok.
Will it cause any downtime disabling smartport?
Dave
Hi thanks for the reply. I have been speaking to Cisco about this problem and it appears that we either need to enable multicast ont eh 3750's by purchasing a license upgrade and allowing the 3750's to do the routing for the 55 VLAN, or move the con...
Hi, thanks for the update.I found this:-https://supportforums.cisco.com/docs/DOC-21728Which says how to setup the 2112 controller, which i have followed as best i can, but it still isn't working
Hi there, No answers yet Just an update. I have found a wireless access point and plugged that into the 55 VLAN. Configured my iPhone up to that wireless and it works with the Apple TV plugged into the same VLAN!So basically it IS the cisco wireless...
