About michael.ray-4

michael.ray-4 · 06-07-2007

Hello, I am performing an upgrade from a NPE-300 to a NPE-G2 processing engine on a 7206VXR router. I am trying to get the router to boot from a config file on the Compact Flash media instead of the NVRAM. I have entered the command "boot config disk...

michael.ray-4 · 05-01-2007

Hello. I have a 2970G-24-TS-E switch running IOS version LanbaseK9-MZ 12.2-25 SED1. Due to a planned power outage I powered off the switch for the weekend. I powered up the switch on the next business day and received an error "!!! Warning: The switc...

michael.ray-4 · 02-07-2007

Hello, I have a 2651 router that is configured to run DHCP. I am trying to determine if there is a way to log DHCP leased addresses and export those logs to a syslog server. I currently have a syslog server set up but do not see any entries for DHPC ...

michael.ray-4 · 06-08-2007

Mohammed, you are absolutely correct. I found out that I was doing the right thing just as you had said. The problem was a lack of understanding on my part. Since this is a new processing engine the flash disk was blank. I configured an interface on ...

michael.ray-4 · 05-01-2007

I was hoping this was not the case. But I am sure you are correct. Must be a hardware failure. I'll open a TAC case. Thanks.

michael.ray-4 · 02-14-2007

I have configured SNMP and traps logging as you have suggested. I connected a client and received an IP address. As of yet I have not seen the event logged to my syslog file. I'll give it some time and try again later. Thanks for your help.

Member Since	‎05-10-2006 05:02 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	6

User Statistics

User Activity

NPE-G2 upgrade question

Error message" !!! Warning: the switch is not usable !!! "

DHCP address logging

Re: NPE-G2 upgrade question

Re: Error message" !!! Warning: the switch is not usable !!! "

Re: DHCP address logging