Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Someone said the ISE API costs money, but I was wondering if someone could break down how the cost works.Is it just pxGrid and OpenAPI that aren’t charged?
Can anyone tell me what is the timestamp in ms seconds or how it display in the timestamp packet capture using mon cap cap buffer brief----------------------------------------------------------------------------# size timestamp source destination dsc...
the router looks fine and show ip bgp is correctR2 can't reach ISP by going to R1 to ISP*******************************************************************************************************R1no license smart enable!!spanning-tree extend system-id!i...
ISP is not far, it's very close by and I think less few miles or walking distanceIt's safe to use I added the second route-map and add permit and made it blank so it allow everything doesn't make any changes so much it's allowing everythingQuestion ...
It was done in the ISP side and I have create lab config for review and any suggestion for best practiceshttps://community.cisco.com/t5/routing/please-check-my-bgp-configuration/m-p/5105208#M399149
