Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I'm trying to setup a PIX501 as an EasyVPN client. This device has been used to test some stuff with dedicated ipsec connections but now I want it back to an EasyVPN connection.When I fill in all the EasyVPN settings vpnclient server 213.x.x.x v...
Hi,I'm trying to setup a RADIUS server to authenticate my users on a couple of routers.Now I've done my initial setup on a 1811 router and everything works fine, moving to a production 2801 router I get into problems. Trying our second production 280...
Hi,I have a Cisco 2801 router connected to the Internet running EasyVPN server and some site-to-site connections.Some of the clients from the EasyVPN server need to be able to 'use' the IP from the 2801 to access other servers in the public internet....
Hi,I'm running a network where we use a Cisco 2801 router as EasyVPN server and several cisco PIX 501 firewalls as EasyVPN clients. Now I just read about the Cisco 3000 series concentrators and every example I see uses this product as a server.Could ...
Hi,I'm working on getting a virutal tunnel interface up and running between two Cisco 2801 routers. I've found some docs about the IPsec Virtual Tunnel Interface which looks very promising but...there are lines like this:crypto ipsec client ezvpn CLI...
I've already did a write erase, and reload back to default configuration. Updated all configuration options and still the same error.So I've got no idea at all why it still keeps complaining about this error. Maybe some file in the flash is broken or...
Tried that, and true the PIX doesn't complain upon chainging IP address. after that, it did a "no vpnclient (vpngroup/server/username/mode)" (so "show vpnclient" reported nothing, save the configuration and reloaded the pix. Set it up again, and as s...
Thanks for your suggestions, but "show crypto isakmp" returns nothing (there are no isakmp lines in the config at all!) and I've probably reloaded the PIX over a hundred times
Thanks for your answer but I'm a little confused. On both my 2801 routers I have the following:radius-server host 10.1.1.1 auth-port 1812 acct-port 1813 key 7 <>Both servers use there own key for radius authentication on my free radisu but that part ...
