Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Before updating my Cisco C9120AXE (fw was 16.x) I was used to change the country code with the following commands over SSH:enableconfigure terminalap dot11 24ghz shutdownap dot11 5ghz shutdownap country <country_code>no ap dot11 24ghz shutdownn...
hello,I have a C9120AXE-E Access point with the latest firmware (17.9), configured with EWC mode so that it is autonomous.I created a WLAN network on the AP, but I face a situation where my client are not able to connect this network. They are unauth...
HelloI have a C9120AXE access point. I'm trying to change the bandwith using SSH command: "ap name AP84F1.4783.21FC dot11 dual-band channel width 40W" but it fails with the following error printed on the serial console: "%RRM_CLIENT-3-EWLC_EXEC_ERR: ...
Hello,I have a Cisco C9120AX Access Point and I would like to activate the FIPS mode.I have not seen any menu for that on the web page of the Access point, and not found the wanted command on the serial interface (I guess it is possible at least by t...
@Mark Elsen Actually this displays:ewc#show running-config | inc countrywireless country DEwireless country GBap country FRSo not good. Let suppose I remove the not wanted country codes and I have one line only.Then, if my understanding is correct I ...
Not bad, this is working to go back to FR, but then it's not working to go back to DE again.The purpose is to change remotely between several values so I need both directions.Thanks
I do "show ap name AP84F1.4783.21FC config general" to read the current country code: Cisco AP Name : AP84F1.4783.21FC=================================================Cisco AP Identifier : 84f1.47ad.1160Country Code : Multiple Countries : FR,DE,GBReg...
@Flavio Miranda thanks for the quick reply.Yes sure the client doesn't need the access to the web interface.I just double checked the PSK passphrase and it seems I have not written it properly the first time, now seems working!So, a big sorry for the...
