Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
All,We are looking into implementing PFR version 3 to take advantage of our dual MPLS service providers. Looking at most of the Cisco documentations on PFR version 3, it seems like it is tightly integrated with Intelligent WAN which takes advantage o...
Yankee123,
Ether-channels are either layer 2 or Layer3.
You can not have switchport commands and "IP address" on the same interface as it shows on po1.
Thanks
Hello,
Good to see some real life implementation of IWAN out there.
Last year, in our implementation, we tried to decouple DMVPN from IWAN and ran into quiet some issues. Policies were not understood and/or implemented by the remote MCs and BRs. I ...
Keep in mind BBSM is a EOS/EOL product. The recommended replacement for the Cisco BBSM is the Cisco NAC Appliance (formerly Cisco Clean Access). Where support for wired deployments is not required the Cisco Unified Wireless Network (wireless LAN cont...
