Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When I use Cisco AnyConnect for VPN, I encounter an error as shown in the screenshot. After logging in, the error occurs at 30% loading. With the same user, I can log in normally on other machines. I would greatly appreciate your assistance.
I have 1 blade DELL and 2 switch cisco n5k e1/37-40 <=> Te0/49-52with N5k-1 & vsys01-dell, use port channel 4 member, any work normalbut with N5k-2 & vsys02-dell, only 1 port working, 3 other port status up but protocol downshow int po1 in DELL swit...
I want to ask I have Router Cisco 2911 base.When I set VPN site2site with 2 other site, there is only 1 site up, the other site up phase 1 but down phase2So do I need license for 2-3 line VPN site2site on 1 interface on this routerTks vrm
I set VPN site2site between Cisco2911 and FGT v6.4Config as attachso phase 1 done, but phase 2 downThe things is, I don't set crypto policy with DH group14, so phase1 up with this DH group. When I change DH group on FG to group2, phase1 down.pls help...
thks marce1000 for reply, but its not working although I follow your guide Dell(conf-if-te-0/51)# do sh run int te 0/51!interface TenGigabitEthernet 0/51no ip addressmtu 2500!port-channel-protocol LACPport-channel 31 mode active!protocol lldpno adver...
