Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I set a port security for one port, after I did this config about 3 mins, this port shutdown. But I check my configuration, the mac address is correct.What will cause this happen? Can somebody help me check with this? Thank you!2015 Aug 19 13:41:50 ...
When I tried to change my DCA interval parameter. It looks like change successfully. But in fact it is still 10 mins. And I can't change my "DCA Channel Sensitivity" . For the low, medium and high, they are all 5dB. Can you help me check this issue?
Our customers in the same area lost connection to network. Their computers have no wireless signals for about 2 minutes.I check the WLC logging. I serched by using their MAC address, and found two of their mac address appear at that period.I don't kn...
1.set port security 3/48 enable age 0 max 1 shutdown 0 unicast-flood enable violation shutdown it's catos2. It's a tool in fab. I'm not familiar with it. I only know the tool has a computer to control it. And we will use the mac of the computer to c...
And when I show cam dynamic 3/48. There is no mac address.* = Static Entry. + = Permanent Entry. # = System Entry. R = Router Entry.X = Port Security Entry $ = Dot1x Security Entry M = Mac-Auth-Bypass Entry ...
Hi Tommy,You can see from my captures about the detail information. Port 3/48 connect to a Tool. Recently they replaced the computer of this tool. After they replaced it , I enabled the port security again. As I mentioned a few mins after I enable th...
This problem is solved now. Our RF group is not stable. Change the DCA need 100 mins to take effort. These two WLC cannot sometimes can not find each other.
