Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi,Experts:In "show platform software cerm-information",there has a qty of number of IPsec tunnel,for example:Device# show platform software cerm-information
Crypto Export Restrictions Manager(CERM) Information:
CERM functionality: ENABLED
-------...
hi,Expert:Here is my scenario, two sites are connected by Metro link,and each site has INTERNET access. Requirement: if SiteA FW down,then SiteA business should re-route to SiteB via Metro link to access INTERNET,same as reverse.Question: How to all...
Hi,allHow I control the Bonjour forward from specified source vlan to destination vlanMy scene has total 3 floors, two SSIDs and per vlan/subnet per floor for each SSID, detail as below.SSID-A1F:vlan 101 with bonjour-serivice-1F2F:vlan 102 with bonjo...
hi,GldenJoe:Many thinks to your helpful guide.My switch is C9300X-M,so it should support uplink SVI ,i.e 10.1.1.2,as its manangement IP. I will verify it.On this implement, actually, each site has two non-cisco FWs run as a FW HA, and two C9300X-M bu...
Dear nicdc01:well received,and I also deployed FW HA with multi-WAN in each site, same as the solution mentioned in this article,but customer further required site resilience when FW-HA totally down on a site.SiteA is a network,and SiteB is another...
For MX bonjour forwarding,I can config "Service VLANs" and "Client VLANs",but at MR bonjour forwarding, I can only config destination VLAN ID i.e. Service VLANs. unfortunately,I didn't deploy MX in my network.How if I only allow VLAN 101 and 201 on a...
