Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When I tried to access the Core Switch using the command config term, I received the following message:"Config mode cannot be entered during standby initialization or when switch is in recovery mode."This message persisted for about five minutes, and...
Dear Engineers,Good day!I have an important technical inquiry and I seek your assistance.One of the requirements is to perform (SNAT, DNAT) for several servers, but they already have NATing configured. The request is to set up another NATing on a dif...
Greetings,I hope to help you clarify the concept of (ACL, Allowing and Denying).I have a Cloud portal where I hosted Two Servers, and the support team added a section for me (Firewall), which is just an ACL.SRV1 IP: 20.200.92.20SRV2 IP: 20.200.108.10...
I executed the following command on the switch in the environment I work in:"mac address-table static XXXX.XXXX.XXXX vlan X drop"My intention was to prevent a single PC from accessing the network. However, my curiosity led me to create a lab on eve-n...
Yes, they function as a single switch using StackWise. Yes, it seems the standby switch fails and then recovers. Any advice, please? Could this be due to flapping, or what do you recommend I do? Should I reconfigure StackWise, or is there another sol...
The device is C9606R; hopefully, it will be useful. However, I can provide the IOS version later when I gain access to the device.Please find below what happened to me, and thank you for your support.I noticed that the ports of the standby switch wer...
Dear MHM,What I meant is not "static NAT and dynamic NAT," but rather SNAT = Source NAT, DNAT = Destination NAT.SNAT is the standard when I want to translate a private address to a public one so that it can access the internet.For DNAT, I believe the...
