Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 2 DHCP pools on a cisco 9300 switch. I want to modify the pools to exclude specific ip ranges. Do I have to delete the pools then create the exclusions and then recreate the pools or can create the exclusions and simply reload the switch?
I have an MR36 that pulled a bad ip because the port was configured with the wrong vlan. I removed the unit from the dashboard, reconfigure the port. The unit is pulling the right address now but when it get imported into the dashboard it shows the ...
I have a core stack of 3 catalyst 9300-48 switches each running firmware Version 17.12.1rAs the title suggest I'm trying to configure Inter vlan routing between 2 vlan'svlan50 has the SVI of 172.127.30.1 255.255.254.0 which is the default gateway for...
The switch port is set up as a trunk port. interface GigabitEthernet1/0/38 description WiFi AP test port switchport trunk native vlan 26 switchport trunk allowed vlan 7,26 switchport m...
hosts in VLAN 50 cannot ping a host in VLAN 110. hosts in VLAN 50 can ping default gateway of VLAN 110.Same in reverse. 110 host cannot ping a VLAN50 host but it can ping VLAN50 default gateway.
For security I blocked the actual serial numbersCORE-S1#show license allSmart Licensing Status======================Smart Licensing is ENABLEDExport Authorization Key:Features Authorized:<none>Utility:Status: DISABLEDSmart Licensing Using Policy:Stat...
