Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My querry is, if I have a AP I am installing it in the remote site, then on the switch what should be vlan id I should keep where the AP will be hooked up. My connectivity from Remote site to Data center is Layer 3, MPLS network. pls. suggest.
Hi All,Just have a basic querry, What is the default mode of 1142 AP. When it's shipped from Cisco, Does it works as LAP or it can be used as a Autonomous ?Also, incase we just get it shipped from Cisco, does it have any default IP address that we ca...
Just one more advice.. keep the SSID at both the ends similar. I mean, its case sensitive.. so be aware of it..sometimes this small mistake takes a long time to get noticed and corrected
