Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
friends, i need to configure 3700 series router as terminal server. any link would be greatfuli see lot of posts with 2500 series being configured as terminal server.thanks in advance.Sara
Hi, I have two switches, connected back to back to configure etherchannel.i do have ethernet ports and sfp ports.is it possible to bundle ethernet and sfp ports and configure port channel.i dont see any doc specific to this case.regardsSara
Hi, We have lot of 6500 switches in our office, and also n number of hubs in each floors and each department, now we are in the plan of replacing of all the hubs to switch, how can we find it switch through command line other than physically identif...
Is there any tool or software through which i can manage vlan and ip address for my network. there are more than 500 vlans, which i am maintaining excel sheet as of now. pls let me know if there is any other way to maintain the same.
enabled debug isdn Q931 and Q921, recieving the below logs, Layer 1, 2 are active, layer is also fine, still not sure, as tested by telco, voice and data calls are happening in this line, Error messageRouter#isdn test call interface s2/0:15 401922500...
Lets go for equal cost case.if there are more than one route with equal path for a single destination, in this case, what will be number of entries routing table.how many entries will be there in "Successor" & "Feasible Successor".Is it like more tha...
thanks for the same, need one more info...if we are using unequal cost and variance is one, then as u told, LB is disabled.while the case of equal cost, what would happen. moreover what will happed if variance is not configured, any default value is ...
jerry, you are right, but there is PFC card, in sh module status, you can see L3 Switching Engine, where we have a similar switch being used for L3. also this switch was earlier used as distribution switch, still working on it.will share if done.r...
I need to enter all these commands fully..SWITCH1(enable) set rspan destination 11/22 111 inpkts enable learning enable11/22 is the pc where ethreal software has been installed and 11/8 has to be monitered...where all the ports are in vlan 111.but st...
