I have a C9300L as the Core switch where I have the interface vlans configured for the L3 and I have some C9200L as the access switches for the end users.In the Core C9300, I have the DHCP server and the pools configured and some users are not receiv...
The 9300 is my Core switch where I have the interface vlans created and the dhcp pool. I dont have dhcp relayThe 9200 are the access switches that are conected via trunk to the Core.
Yes, I applied the commands to the correct interface vlan. I see that Directed broadcast forwarding is disabled by default.Vlan15 is up, line protocol is upInternet address is 10.3.150.1/24Broadcast address is 255.255.255.255Address determined by non...
Hi Richard,Yes, is an unusual event because I have users in the same access switch working without problems and others that have the problem. Not always are the same users, and after a few retries of flushdns in the PC or reconnect the cable several ...
Hi MHM,See the result of the command, in the Core I see the ICMP Redirect and BROADCAST Queue Drops increase on the Core, in the access switches I dont see the counters increase (Queue Drop is 0)C9300L_CORE#show platform hardware fed switch active qo...
Hi BalajiI have a Core device connected directly to all access switches in a star topology (see attached)There are more vlans, also with the same problem. All the dhcp pool are created in the Core.We are using version 16.12.3aDHCP snooping is not ena...
