Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have a question regarding Cisco ACI.
A customer asked why a duplicate IP fault is appropriate when two different MAC addresses are registered as endpoints in the same EPG for the identical IP address.
Based on the ACI fault search tool, I fo...
Hello
I am configuring a DHCP pool to use a Cisco 2960 switch as a DHCP server.
If the device IP of the 2960 switch and the IP range used for the DHCP pool are different, routing functionality is required.
Since the 2960 is an L2 switch, I understan...
For flex mode, I understand that i use the 802.1q trunking method to tag specific vlan.
I understand that when I use the ap as flexmode, I need to set the port to native vlan trunk.
When I set up a native vlan on an ap connection port, I wonder what ...
I tried a lot to switch to flexconnect mode, but the join with WLC failed
the poe and ap connection ports as access ports and access vlan,
it becomes a join with wlc regardless of the ap mode
However, if you switch to trunk and specify native vlan, ...
Thank you for replying to me, ScottBut now all AP equipment is configured as static, so we should have designated the test AP as static as well.May I ask you one more question?If the behavior of trunk native vlan 100 and access vlan 100 were the same...
First of all, thank you very much for your response, Scott By connecting the console, the ip address of the AP is statically specifiedIs there anything else I should check in this case as well?
