Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have copied down a new boot image to the flash of three switches in a stack. I have issued the command "boot system switch all flash:" including the name of the new boot image. However, I need to formally schedule the rebooting of these switches ...
As anyone reading this probably knows the Cisco MSE 3350 comes with two NICs. I want to configure them as a team bound to one IP address and send each to a separate 6509 switchport all in the name of redundancy and failover. Has anyone done this? ...
Hopefully this will be an easy and straightforward question to answer: Can I setup DHCP assigned IP addresses and Static assigned IP addresses simultaneously on the same WLAN? Assumming that static addresses are already allowed on the controller/Wi...
Starting a few days ago, two of my WISM-based controllers generated this message: "Keepalive messages are lost between Controller 'xx.xx.xxx.xx'and Master.Please check the controllers port configuration,any software or hardwareincompatibility issues....
