Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,We recently migrated our Wi-Fi authentication method from PEAP to TEAP(which involves EAP chaining machine and user authentication). Since the migration, we have been experiencing an intermittent issue where users are disconnected after a succ...
Hi All,We have ISE deployment in distributed deployment architecture with two PSN nodes and two PAN nodes. In the PAN failover setting the primary health check node is set to PSN01, and the secondary is set to PSN02. We are currently seeing alarms st...
Hi All,Recently, we migrated our enterprise Wi-Fi authentication method from PEAP to TEAP (inner auth EAP-TLS). Since then, many users have been experiencing disconnections while their sessions are active.In the morning, the Wi-Fi connects and works ...
Hi All,I am currently expanding an existing Cisco ISE cluster. The current setup consists of two dedicated nodes: one acting as the Primary Admin/MNT and the other two nodes as a Policy Service Node (PSN).I am now adding another appliance which I int...
Hi All,We have initiated the rollout of user authentication using TEAP (transitioning from PEAP). During testing, we observed the following issue When a user clicks the “Forget” button on the Wi-Fi profile, the system reverts to PEAP as the default a...
I opened a case with Cisco TAC, and they indicated this is likely not an ISE issue, as ISE is successfully authenticating the sessions. They suggested looking into the WLC side. Could you please advise on what specific logs or configurations I should...
Hi @Cristian Matei The message is appears every 30mins.Attached the screenshot No Health Check poll from the Primary Health Check Node : psn01in the past 30 minutes.
