About danimelocoton

danimelocoton · 05-09-2017

Hi all, I was deeping in forum about this concepts and how they work and in which terms we can use them. But I'm very confused about how will they work. I'm preparing a QoS config for ASR1006 in one TenGiga subinterface. The subinterface connect to...

danimelocoton · 01-02-2017

Hi colleagues, Last Saturday we had a problem in our network and a router reloads, due to power faulty at rack and reboots. All networks configured in a subinterface administratively down, began to be advertised through BGP. The networks announced ...

danimelocoton · 12-30-2016

Hi guys I have questioned by our NOC support about a possible issue in an GigabitEthernet interface of 7206VXR with NPE-G2. I see input errors increasing at the same time as ignored errors. Deeping in the forum I find several discussions trying to e...

danimelocoton · 01-03-2017

Hi Paul, Sorry, I didnt copy all show ip int brief command result. This is what I saw: sho ip int briefInterface IP-Address OK? Method Status ProtocolGigabitEthernet0/0 unassigned YES NVRAM up up GigabitEthernet0/0.2032 10.110.11.86 YES NVRAM up up ...

danimelocoton · 01-03-2017

Thanks for your reply Enrico. That's the point, network connected is redistributed correctly as you tested . Now it's not possible to do anything in that subinterface, because we deleted it. Attached in my first post you can see info related to sta...

danimelocoton · 01-02-2017

Thanks Leo for your reply. We`ll contact to our transport network provider to be sure is not related with noise. But I see this ignored errors, input errors increase at the same time as RX MAC Discard Frame counter What about RX MAC Discard Frame co...

danimelocoton · 12-30-2016

Thanks Leo for you reply. As you can see router is uptime more than a year, true, but interface counters have been cleared yesterday and again this morning. You can see the output in my first post, but I issue the command again now. I've been monito...

danimelocoton · 12-30-2016

Thanks Leo, You see insignificant cause you're viewing totals. When you monitor this in real time, ratio is 1 input error every 3000 input packets. The question is which is the cause of this errors and how to solve it and if it's not a "real" erro...

Member Since	‎03-01-2016 05:21 AM
Date Last Visited	‎02-23-2024 12:04 AM
Posts	8

User Statistics

User Activity

Policer vs Bandwitch vs Shaper

Should Router running BGP and redistributed connected advertise networks when subinterfaces is in shutdown?

7206 VXR NPE-G2 input/ignored errors increasing

Hi Paul,

Thanks for your reply Enrico.

Thanks Leo for your reply. We

Thanks Leo for you reply. As

Thanks Leo,