Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone,Is there a doc available for setting up multple WLANs, with having each wlan on its own vlan?THanksEquipment:2106 WLAN ControllAironet 3502 AP
Hello,I am trying to enable more channels in the DCA channel list for 802.11/b/g/n. However, when i hit apply i get this message: "802.11b network needs to be disabled to apply changes to DCA."I do not see a spot to disable B. Would this be somethin...
Hello Every,I have just purchased three 3502i access points and am having a hard time getting them to communicate with my 2106 controller. Currently, i have the APs plugged directly into the PoE port on the WLAN Controller. From everything i have r...
If I am trying to run directly out of the WLAN Controller to the ISP switch, is there anything specific I would need to do? I am still not able to get this to function properly.
Yes, this seems easy enough. However, I am having issues with the dhcp. I am attempting to do this with dual ISPs. The secondary interface sends out the dhcp broadcast, but does not get a response.
I've attempted to correct this problem with no luck. Is there a way to connect to the access point and set a static IP? The normal CLI set ip option doesnt seem to work. And the "Getting started" guide has not helped.
I believe the IP address may be the issue. I did manage to find the device listed in the neighboring interfaces section, listed with no IP address. I have followed the settings in the manual for allowing the proxy of the dhcp. It appears this is not ...
