Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a policy to take backup of our configuration before we make any changes. We do this for any of our Cisco routers or switches or firewalls.We would like to do the same when we make changes to our Meraki MX devices also. Before making any cha...
We have deployed Meraki MX in our Datacenter in HA mode. We will be configuring BGP between the Meraki and our Core layer3 switches. I would like to know if Meraki MX BGP implementation support graceful restart. Below is example configuration fro...
At many of our sites, we currently utilize Cisco WLC and Access Points. Our objective is to implement a guest captive portal system with a sponsor feature. Essentially, guests would input their details, including a sponsor email address, to request a...
I would like to know if there was a way to collect username, hostname and operating system info from our anyconnect users. Currently we have syslog enabled that tells us what time users connected etc but we would like to get more info like the hostn...
Hi, I would like to add a wait time of 120 seconds before sending email using EEM script. This would give enough time for the failover convergence and ensure email is sent using the backup link. Below is what i have configured so far.
Also i would...
Thank you very much for the reply. Isn't backup and restore a basic functionality that all products have? Any product whether from cisco or any other vendor has a backup feature so if someone makes a mistake, they can restore the config.
Hi,On the core switch side we know it supports graceful restart because we are already using that BGP feature with other BGP peers.On the Meraki side we are using Meraki MX 250. We would like to know if the BGP implementation on the Meraki MX 250 su...
Hi,Thank you very much for the reply. We do not want to use the portal on the Cisco WLC. We just want the guest users to go to the meraki, get a captive portal display, get approved by sponsor and then get guest access. I will review the link you ...
Hi,
I am trying to create an IPsla monitor to check latency only. If it goes above say 100 ms I want to trigger an action. Please can you post the IPsla config you created to track latency?
regards,
Ismail
Hi Joe,
Thank you very much for your help. Below is the command i used in my EEM applet
action 140 set bgps "$_cli_result"
and then used it in the body as you mentioned above.
