Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Please I do need assistance... I am working on a catalyst 3850 switch, I plugged a cisco 10G sfp+ SR module to an interface and connected it to a firewall.The port light alternates between orange and green color, though the orange color stays a...
Please i need guidance with downloading the autonomous ios for 3500 Access point.i have checked sofware.cisco.com for the device model, i cant find specifically the 3500 series. so i know its out of support but is there no way i can still download th...
Firstly,i want to appreciate everyone that took out time to contribute in providing a solution to the challenge i posted few days ago... I deeply appreciate. Everyone's response and contributions were 100% valid towards providing a solution...So yes,...
yeah, i didi have issued the following command to verify and troubleshoot :"test interface transceiver" and show interface transceivershow idprom interface te1/0/1show loggingshow interfaces, .... And a couple other basic commands to verify layer 1.....
i have configured this, still same issue...And the thing i have verified using various commands, and the interface seems fine. Also to note, the port is a routed port.
i did this as well, both on the firewall and on the switch. though on the 3850 switch, the duplex command does not work. But i hardcoded the speed. The interface is 10gb data rate and hence it uses full duplex by default.
Yes i am... the error you highlighted in red is not the output from the interface i am troubleshooting...But yes i am using a Cisco sfp-10G-SR transceiver
