Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi thereI have multiple Mail servers behind an ASA 5505 (v rel 8.2.5). All inbound smtp 25 traffic is natted to a mail gateway server placed in the LAN, for example172.16.40.1 netmask 255.255.0.0. This server is receiving mail for several domains an...
Dear AllI have an issue with correctly configuring sg300 layer 3 switch behind ASA 5505 (incl Security Plus License)The setup is as follows:CISCO SG300 is configured as a Layer 3 SwitchNative VLAN 1: ip address 192.168.1.254, default route (inside in...
Is there someway I can reset an unknown password for IPS? The default password "cisco" is not workingShow version shows following informationMod SSM Application Name Status SSM Application Version--- ------------------------------...
Hi thereFor one of my Clients I need to setup a network VLAN configuration which exists of an ASA 5505 (security plus license) and a cisco catalyst 2960I already setup one of the ports of my ASA as trunk and did the same for my catalyst. Now here is ...
Okay I think I got it workingI came across some articles that talked about hairpinningI added the following lines to my configsame-security-traffic permit intra-interfaceglobal (inside) 1 interfacestatic (inside,inside) 209.x.x.1 172.16.40.1 netmask ...
Julio See attached pdf for network diagram. Thanks for notifying me about the log. I will have to look into that. I monitored the logging for a while, but there's no logging of smtp traffic at all.How can I rate the replies? Cannot find itNever mind....
JulioYour understanding is correct. This is exactly what I want to achieveHere's the logging from the ASA%ASA-7-710005: UDP request discarded from 0.0.0.0/68 to outside:255.255.255.255/67%ASA-7-710005: UDP request discarded from 0.0.0.0/68 to outside...
Hi Julio,Thnx for helping me outI'll try and explain a little betterI have multiple customers with each a seperate mail server on my corporate LANCustomer A with email domain companya.com , Customer B with companyb.com, Customer ETC with companyetc.c...
ThomasYou were right I figured it out already. I used the wrong ip address for gateway to the different subnets. It should have been the ip address 192.168.1.254 as I used 192.168.1.1 which is the ip address of the ASA itself.I also made sure the upl...
