Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I want to be able to dampen a specific set of flapping routes in my bgp table using a different set of parameters from my default dampening.From the IOS docs, it looks like the following would work:*****ip access-list standard dampen-routes permit ...
I have a PIX 515E v6.3.3 that is currently in place and has statics and an access list on the outside interface to allow http and smtp access in to the mail & web servers.I now have a need to allow an deveoper ftp access to the web site for posting c...
Two 7xxx routers using MLPPP on two T1's, and running BGP over the multilink interface. Interface runs great for a few days, then suddenly stops sending traffic and the BGP session goes active. On one side of the router, the router is unable to pin...
Thanks, works great got thrown off by the documentation under "set dampening" in the Router Command Reference, which shows it in a route-map on a neighbor statement. Should have check the bgp dampening command...Thanks
Acutally turned out to be a bug... Reference CSCec00268. The key think to tracking this bug down was to note that the interface was throttled using the "show int mu1". Once "throttles" was put into the seach string on Bug Toolkit, this popped out....
