Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My question pertains to using either BGP or HSRP at both the internet edge module and or WAN edge module for failover. I CANNOT realistically think of a situation where I would failover between two devices using HSRP at both the internet edge and WAN...
Hi,I am faced with a challenge with a setup which was previously running in a flat network without a firewall. They had a proxy server running which did NATTING for them on the WAN interface whereas the LAN segment was plugged into the LAN interface....
Hi,I am trying to create an IPSEC remote access vpn and am working for the first time with Network Object NAT on a 5512 X architecture with 8.6 OS. I would like to know how to create a NONAT scenario with users on the other side using a NAT 0 nat ent...
Hi,We are recieving two separate last mile fibers from our ISP. We are receving two separate /30 subnets from the ISP and a separate /28 pool. Now the first pool for instance is x.x.x.128/30, the second one is x.x.x.136/30 and the last pool is x.x...
Hi,I went through the configuration guide for 4500 series switches for NSF/SSO for failover between Sup's. I just wanted to know that that are we supposed to run the SSO command on both of the supervisors? Secondly, are we only supposed to run the ns...
Hi Marcin,Thanks for your reply in this regard. The WCCP Server protocol requires a service running the WCCP client protocol at the proxy/client end. The router/ASA running WCCP would forward requests that match the WCCP ACL to the Cisco Cache Engine...
Hi,Yes, but that wouldn't be the best design scenario now would it? It would create a double NAT scenario with NAT being configured on the firewall and the Internet Edge router. Also, it would defeat the main purpose of obtaining a /28 pool from the ...
Hi,Well, after further investigations with the client and their ISP. I have learnt that the two /30 pools were for running eBGP with the ISP. The links were configured for failover using the Local Preference attribute. The other /28 pool was not assi...
Oh great and what about the following commands:Non-Stop Forwarding:Switch(config)# router eigrp as-numberSwitch(config-router)# nsfDo we neet to apply them on other routers in the domain to make them NSF aware as well so that when they receive the ne...
Very true indeed sir! Thank you for your valuable insight into the matter. Thanks for pointing the design flaw out. I meant to say Distribution to Core. Cheers.
