Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,In WLC 8.6, we started supporting volume metering by allowing radius accounting interim interval to be set at a granular 60 seconds level.config wlan radius_server acct interim-update intervalWith this said, is there a way to setup ISE to disconn...
Hi,How do I achieve the below use cases with ISE and Wireless?Only allow access to the network from 9am – 6pm, and disconnect any “active” clients after 6pm?Assign a Radius av-pair AIrespace-QoS-Level to clients who authenticate from 9am-6pm, but as...
Hello,I'm trying to install nexus 1000v and came across the below prerequisite.The below release notes for Nexus 1000v statesVMware and Host Prerequisites The VSM VM control interface must be on the same Layer 2 VLAN as the ESX 4.0 host that it manag...
Shutting wlan off will not address the 2nd use case.Which is to reassign a new qos profile to the active user after office hours, so the user will enjoy an elevated bandwidth contract privilege.Wouldn't setting reauth timer to 30 mins interval impact...
Is there a way to set this Re-authentication timer to reauthenticate clients at 6pm?This is because different clients might join the network at different time of day within the 9am-6pm window. It'll be a challenge to figure out the exact timer for th...
Hi,Time and Condition on Authorization Profile will be enforced for new connections/clients and not existing clients.If the existing client is still connected to the network, the only way to assign a new Authorization Profile to them is via Change of...
My mistake, I think I've read through it very quickly..I should be able to achieve this when i define the control vlan in the system-uplink port profile as well..
