Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have configured cisco 7200, the configuration is as below BHX-102#sh run interface g0/3Building configuration...Current configuration : 272 bytes!interface GigabitEthernet0/3description To_BPE_LAB_Cisco9200_0001bandwidth 100000ip address 1.0...
Hello All, I am applying QoS on interface that has traffic going, BPE_LAB_C1111x_0002#sh interface g0/1/6GigabitEthernet0/1/6 is up, line protocol is up (connected)Hardware is C1111X-ES-8, address is ac7a.5622.9a0e (bia ac7a.5622.9a0e)Description: R3...
Hello All, I am using cisco c9200 catalyst, I have traffic in this router 20000 frame/second and my bandwidth can handle 12500 frame/second my frames are 1000bytes, I am seeing almost 0.1s for end-to-end delay and 37.5% as loss. i expect to see chang...
Hello, I have a network topology as below:R2 - R3 - R4 | R1My bandwidth are 100Mbps, queue sizes are 1000 packets, fifoand I am sending 12500 frame/second and 1000byte each frame , from R2- R3 and another one R1-R3Loss is around 1.96%...
Yes, It says the queuing policy is not supported on vlan, could it be the issue why this router experience high delay ?I am still stuck on the previous problem which this one has delay over than 4 times bigger.Even applying traffic more than bandwidt...
This doesn't have the option tx-ring-limit , and I wasn't able to find anything that could help me to configure this and this is my question how can i configure this ?this is part of sh controller output for this interface Output:pkts 3500829855, byt...
Yes I get this from IXIA, as average end to end latency. The topology is as below ixia | IXIA - R1 - R3 - R2 - IXIA | R4 - ixiathe router R1, and R4 are from family C111...
I am sending 13600 frame/second each frame 1000 bytes , my bw can handle 12500 frame/second given 100Mbps, and on ixia i am seeing 8% loss and 0.4s end to end delay ,
I have a network and I want to have a simulated version of this network on omnet++ and i need to be able to tune some of the parameters, this is the result of sh controllers for router C1111 family, GE4 Statistics:Input:pkts 126428665, bytes 21185786...
