Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've been searching for some config examples, but don't seem to be coming up with much on this. I have 2 AP1232s that I'd like to use temporarily as a building to building wireless bridge to trunk 6 VLANs to my new office (100 yards away). I've got...
I'm attempting to set up a PIX to firewall for devices on a valid IP subnet. This is a 506e, with only two interfaces.I'm having trouble finding a config example, and wondering if that's because this isn't a supported configuration.Any pointers?Than...
I am attempting to configure a 2611XM running 12.2(15)T7 as a "customer connection" VPN router for a client who connects to serveral customer networks with overlapping RFC1918 space. This router has f0/1 connected to the DMZ of a PIX, which PATs all...
I have a 3660 with two T1's from different providers, running BGP. Our ASN space is on f0/0, with the two T1 serial interfaces having a serial address on their respective provider's networks.I am attempting to set up an IPSec tunnel, and have done s...
I have an AP352 that shows no errors (that I can see) on boot, appears to be configured correctly, latest firmware, clean config, shows the Requested and Actual status of the radio is up and up, yet shows no traffic on the radio interface. I don't s...
A combination of Layer 0 problems (stupid engineer - me) and not knowing if what I was trying was possible made me not contune on beating my head againt the wall. Based on your message I was able to get things working as expected.Thank you very much...
OK, that's pretty much what I thought...I'm just being a bit too general in my statements.What I have is:Edge Router interface (111.111.111.193/29)----(111.111.111.194/29)PIX E0--PIX E1(111.111.111.209/28)With the hosts to be protected on the E1 inte...
I probably wansn't as clear as I should have been in my first post. What I'm looking to do is have valid IP blocks on both interfaces.Configuring no nat between the subnets, specifying allow ip any any from inside to outside, and pointing an "inside...
Thanks for the idea. It doesn't seem to make a difference in this case. Unless I'm interperting the output incorrectly, it appears that NAT isn't working at all....when I try to hit one of my inside globals (with ping or telnet, for example), the c...
