Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a customer that has a need to get rid of the Securit Warning users see each time they log onto the Guest Wireless and go to use the internet. I believe the best way to do this is to install a 3rd party certificate. I found this link:http://...
I have a 1252 that has joined our WLC 4402. I have checked the controller config and everythign looks good. I have WMM policy to allow, WPA2+AES,the radio shows that the channels are bonded, the channel width is set to 40MHz. I have a laptop that ...
I am looking for some help on how to create a rule that will e-mail me once my DNS server goes down. I have tried doing it several different ways, but with no success and am hoping that someone might know how I would do this. Thanks in advance.
*Edit* Sorry, this should be under wirless help. I just noticed it is in wrong forum.I am having a problem in a network we having where 3 APs seem to continously and randomly go down and then come back up. They are all connected via POE and all go...
Hello,I was checking out a setting in our WCS under the Location Server and trying to view the History Parameters but keep getting an error. It says "Wired Client History internal is less than 1 minute."Any ideas on how to fix this would be greatly ...
Was your ethernet connection the one you orignally used? If so, it is likely that only the MAC address of it is configured in Call manager to work with your IP communicator. I believe your wireless card has a different MAC address which would need ...
I have found this to be part of the WCS itself. When you log into the WCS, go to Monitor>Maps then choose the building and the specific floor you want. From there go to the drop down box to the right where it says select command and choose planning...
If you are considering upgrading to 6.0, here is the section of the release notes for the WCS that concerns that:http://www.cisco.com/en/US/docs/wireless/wcs/release/notes/WCS_RN6_0.html#wp44448As for the WLC, here is that section:http://www.cisco.co...
Have a look at this:http://www.cisco.com/en/US/docs/wireless/controller/5.2/configuration/guide/c52ccfg.html#wpmkr1316150As already mentioned, be sure you have WPA2+AES or Open, and have WMM mode set to allowed.Also, just curious, when you are connec...
