Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Cisco Community,We have Nexus 5k (5548) on version 7.3(3)N1(1) and we want to configure radius on it . Subjected Bug CSCva13731 says 5k (7.3(0)N1(1)) may end up in endless boot cycle if its authenticated via Radius .I just want to know if this...
Hi @ahmad82pkn I know this thread is very old but if you still remember how did you figure out that one VLAN which was causing this issue . I have similar issue with my 4500 switch . But the strange part is CPU spiked after i removed one vlan from th...
Hey @Leo Laohoo I need to upgrade cisco 4500X-16 from 03.06.07.E to 3.11.10E and i have ROMMON version (15.0(1r)SG10). Can I go for the upgrade with the same ROMMOM version or do i need upgrade it to minimum of (15.0(1r)SG11).RegardsRahul
Hi @balaji.bandi ,Thanks for your response . I also want to integrate with AD but via radius . I have rolled out this thing in complete network and I just got stuck with this nexus on version 7.3 as i read one of the post that nexus ends up in endles...
Hi @Philip D'Ath , I am getting the same error and now a bit confused reading this thread . In the first post you have asked to check "users" if we have local network defined .But later you asked to keep 0.0.0.0/0 with users unchecked . Could you ple...
Hello @Giuseppe Larosa ,I did try that. It shows invalid command. And when i do show feature , it does not list aaa hence no option to enable or disable aaa. RegardsRahul
