Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have a Cisco SG300 Switch which I'd like to monitor using CheckMK or really any software.Checkmk successfully received the following things:- Anything about network interfaces- Uptime- System Information- Port Status- POE WattageHowever I'm still...
HiI have gotten a Cisco sg300-28pp switch from my work, which was still in great shape.I installed it, fully reset and simply configured some VLAN's, however nearly daily (sometimes twice daily) the switch and everything behind it gets unresponsive a...
Hi @Flavio Miranda,Thanks for your quick reply!I just tried the following OIDs, and got the following response: OMD[homelab]:~$ snmpget -v2c -c public 10.50.20.2 .1.3.6.1.4.1.9.6.1.101.1.7.0
SNMPv2-SMI::enterprises.9.6.1.101.1.7.0 = INTEGER: 1
OMD[ho...
I have not been able to test this, as the freezes sometimes do not occur for days and sometimes occur hourly.But I can try to get the logs if the freezes appear, and report back.Thanks anyway!
@Flavio MirandaNot sure if I explaind correctly, sorry!I meant, I need to manually reboot the device to get it up again, after it becomes unresponsive.The device does not reboot by itself.
Thanks @Flavio Miranda !It runs on the latest firmware(1.4.11.5)I can't really see a really high CPU usage, however yeah the UI is quite slow, but I tought that is most likely due to the age of the software.
@ksa1 @Flavio Miranda Thanks for your replys!Apologize for the long delay in asnwering, here the RAM logs:Spoiler21474835822020-Apr-09 01:09:52Informational%AAA-I-CONNECT: New http connection for user tobias, source 192.168.1.200 destination 10.50.20...
