About bradleyordner

bradleyordner · 10-26-2023

Hi, The syslog or logging messages on my SDWAN router have a very small buffer. Are these messages, if not sent to a syslog server stored in the admin tech and go back a few days at all? If so, where are they stored?ThanksBrad

bradleyordner · 02-19-2023

Looking for some more details on the weight command in relation to TLOCs. Documentation says the command allows configuration of 1 - 255. Is it correct to say - Primary Link Weight 1 Secondary Link Weight 255 So, for every 1 flow on the primary, 255 ...

bradleyordner · 07-07-2021

This might be simple, but I can't find an answer anywhere. I have two devices, they doing iBGP between themselves and participating in OSPF with each other and two other routers. Mutual redistribution is occuring on both BGP peers, restricted via ro...

bradleyordner · 07-05-2021

Hi, There is a lot of posts about the 3850 Cisco Switch and adjustment of the Softbuffer. We are seeing similar issues on the 3650 and the command is available. The interface is a Gigabit Interfaces and has no service-policy attached although we see...

bradleyordner · 06-08-2021

Hi all, Is there any reason why you would have MTU different inside a single VLAN? I have a problem that is too long to go into right now, but I have a Cisco ASR (SDWAN code) , a Palo Alto firewall and a Nexus switch all in the same VLAN. The networ...

bradleyordner · 07-07-2021

Thanks, this makes sense.I will do another test in the lab and see if I can capture this decision inthe debugs, just want to see if it says anything else. I only been doingdebug ip routing so far.One other question, the remaining OSPF routers only ha...

bradleyordner · 07-06-2021

Ok, will apply and see what happens. There is no QoS configured right now, so not sure if it will have any effect. May recommend they deploy AutoQoS if needed to activate this command? Brad

bradleyordner · 07-05-2021

No command is not present.Brad

bradleyordner · 06-08-2021

This site is a spoke site, so I am just trying to transfer a file over transports back to the Hub site. If I was to use 9K MTU then would all devices Nexus/PA/ASR need it? Would this be L2 MTU or L3 MTU and what would this achieve as if I did L3, t...

bradleyordner · 06-08-2021

I see performance issues for upload speeds to the SDWAN. There is a lot of moving parts and technology in the path as well. I can get multiple TCP streams to reach 50 - 60mbits each, thats it. The total sum can be over 500 Mbits. Downloads with one s...

Member Since	‎05-03-2007 02:25 AM
Date Last Visited	‎08-07-2025 01:04 AM
Posts	179
Total Helpful Votes Received	25

User Statistics

User Activity

Syslog messages inside Admin Tech

SDWAN IPsec preference weight command

Aggregate has lower admin distance?

3650 Soft Buffer and QoS Drops

MTU mismatch

Re: Aggregate has lower admin distance?

Re: 3650 Soft Buffer and QoS Drops

Re: 3650 Soft Buffer and QoS Drops

Re: MTU mismatch

Re: MTU mismatch