Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am confused by an issue with many teleworkers using Z3 and MX64 & 67 for home setups. We have approximately 3000 active peers distributed between three MX250s. Many teleworkers complain about lag and freezing on Citrix applications and IP phones....
We are a healthcare system that has the GE DASH 3000 bedside monitors a one of our hospitals. Last week I upgraded out 4404 standalone controllers from 5.2.178.0 to 6.0.199.4, this was done to resolve a bug issue in the 5.2 code. Now we are getting...
We have a debate going on in our office about buffering logs. We are using CW as our syslog server for a network with approx. 450 Cisco devices (switches, routers, APs, firewalls, etc.). The debate has to do with whether we should be buffering logs...
Ethernet 0, the WAN port to ISP internet modem. Every few hours there are three messages within a four seconds. The first is "device: port0, carrier: false", followed by "device: port0, carrier: true", and then this message again "device: port0, ca...
RaphaelL - Thank you for the advice. We have opened a support case with TAC. TAC has pointed to some other things that we have taken action on and has not improved or resolved our issue. TAC is not giving much info on the Ethernet port carrier cha...
I started this string back in October and we still do not have a solution. I had a TAC case open for a while, but they kept needing debugs from troubleshooting and this issue is difficult to get to repeat. Client debugs are for one MAC at a time a...
I have been trying to get debugs, but I now can't get the issue to repeat. I am not confident that the problem is resolved from the disabling of load balancing and band select on the DASH wlan. I think it took about two days for the problem to appe...
