Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We are deploying new CISCO RV042 router for MPLS branch. (No VPN)core network using CISCO 1921 Router. The problem issue is, I'm unable to ping from branch LAN to my core network. But i can ping from core network to branch (clients local IPs, Rout...
Facing a issue with configuring Port-Channel between stacked switches. (Two CISCO3750G)After configured Port-channel, While both Interfaces are up, I'm unable to ping the host (connected in configured ports).If we remove any one cable, we are getting...
Hi, We have CISCO 1921/K9 Router for ISP Connectivity. We have 2 ISPs.Route policy placed in Interface Fa0/1 for Proxy server traffic through FA0/0/1. with static NAT (Default route)Other public servers traffic through FA0/0 with STATIC NAT for ...
Hi, We are using CISCO 3750-G Switch as Core Switch. VLAN1 is being our Native VLAN since the implementation.This switch is connected with 10 numbers of CISCO 2960 Switches by trunking ports. IP addresses assigned for L2 Switches from VLAN1 only....
Hi All, This issue is resolved now.1) I have changed Server's Binding mode to support LACP.2) Changed the Switch Interfaces configuration with channel-group 22 mode passiveThank you for support.Regards,Ramesh Balachandran
Yes. Port channel in different switches of the same stack. SW#sh etherchannel summaryFlags: D - down P - bundled in port-channel I - stand-alone s - suspended H - Hot-standby (LACP only) R - Layer3 S - Layer2 ...
Hi, This events happening in almost all of my access switches.I have 10 numbers of CISCO2960 switches in network.None of switches matching the counts with LINK-3-UPDOWN & LINEPROTO-5-UPDOWN.SW1#sh int fa0/23FastEthernet0/23 is up, line protocol i...
Thanks for your reply. In this case,Why is LINK-3-UPDOWN & LINEPROTO-5-UPDOWN logs counts are mismatching? LINK-3-UPDOWN (21) & LINEPROTO-5-UPDOWN (71).I have checked with Log count ID. No logs missing. I'm confussed with this logs. Is my switch ...
