Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have three ASA 5505s in three different locations. Each location has its own subnet (10.0.0.x, 10.0.1.x, and 10.0.2.x). I have VPN tunnels from each location to both of the others, making a sort of triangle. Now, I also have one of those ASAs (10...
I have an ASA5505. For some reason, I can;t get remote access VPN to work! I keep getting an error with reason 412 on my Cisco VPN client. Everything *seems* to be right, but then again, I'm using the ASDM to work on this and it wasn't exactly he...
I have a client who has a particular server running some very proprietary software. In order for this software to work, the client must access the server's web page (port 80) via its public IP address. He has to do this from a computer that's actua...
I have an ASA 5505 which I need to open a couple of ports from the outside going in for servers. There are two servers, once handling mail and one for remote administrative access using RDP (Windows servers). The port number for RDP is 3389. If I ...
I have a bit of a problem right now. I'm setting up a new ASA 5505 and have gotten to the point where when I connect it, everyone in the office can access anything they want out on the internet. However, I have a couple of servers, and have been tr...
I hadn't looked back at this thread in a while, but was interested to hear this. My replacement switches are also needing reboots now. One of them I need to reboot weekly. I've now tried putting in the workaround you were given. We'll see over the ...
Okay, I've tried setting it up and must still be missing something. Could you take a look at these? I do know I might have a line or two in there that needs to get cleaned out, but everyone should be connecting to VPN on the 10.0.2.0 ASA and then g...
I guess I need a little bit of clarification. I'm pretty sure that I need to create new names for the and entries, etc. But I already have a "nat (inside) 0" line, and my default route is "nat (inside) 1"... I tried adding the line as "nat (insid...
Okay, I realized a few stupid things I was doing in the client side. Please ignore a lot of this. However, I've now progressed to the point where it's saying "Negotiating security policies..." and then bombs out with "Reason 433: (Reason Not Specif...
