Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have an ASA runing asdm 6.3(3). I can launch the console from the web page but can't install it. Here is my config:ASA 6.3(3)Windows 7 x32bitsJava 6.0.21ehrn I try to install it I get the followingany ideas?Many Thanks!Arnaud
Hello,I'd like to configure a backup connection for our site-to-site VPN but everything I tried doesn't work so far.Here is what I tried:crypto ipsec transform-set ESP-3DES-MD5 esp-3des esp-md5-hmaccrypto map outside_map 20 ipsec-isakmpcrypto map ou...
I've got an issue with the device fault manager on CiscoWorks.Basically, what i wanted to do was to stop the ExceededMaximumUptime reported to many times on all my routers (ADSL interface). I tried to do some tweaking but even if I don't have Exceede...
Hello,Ciscoworks is often reporting the event HighQueueDropRate on some ofmy wireless routers (837, 877w, ...)for example, today : InputPacketQueueDropPct 1.6998109 %but it could be OutputPacketQueueDropPct.basically, the value is set to 1% (default ...
Hi,No, one of them is a cisco concentrator, the 2nd one being an ASA. At some point the two IP addresses will point to the ASA though.Yes I can ping them both from the PIX.The config works pretty much as you said, it actually connects to barnvpn1 but...
I tried to use a new group (4) with exactly the same rule to capture the packets because I remove all the stuff on the old one (2) to stop those alerts for the night, and putted the group on the top of settings priority and it works fine... no more H...
There are no available interfaces from which to capture the data.Please make sure you have installed the WinPcap module. You may need to reboot to complete the installation.Note: This tool only works with Ethernet interfaces.I can't use packet captur...
