Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 2 AIR-AP1232AG-A-K9, and their operational status show as "Downloading". They are not connected to the network anymore. How can I remove these two APs from the WLC (5508, Software Version 7.0.98.0) so that they no longer appear in the controll...
Hi,I am having problem with a simple NAT configuration, and not able to figure out. I can not connect to the Internet. I am not able to find enough information about NAT-NVI: translation failed (A) error.thanks here is the configinterface FastEtherne...
We implemented a paging system that is tied to Cisco Call Manager cluster by a DN.It works fine. I was wondering is there any feature in Call Manager 4.1(3) to secure this phone number so that only people who knows the PIN number or password can call...
has anyone had any problems with telnetting to an ASA 5550 firewall? I try to telnet but connection is refused, it does that for SSH connection as well. i am not sure if there is any other commands that need to be added to allow for inside interface....
Hi all,I have a cisco 2811 router with a NAT configuration and Call Manager 4.1.3. I have setup the SIP trunk to an outside company. When I call an outside number using this SIP trunk it rings the phone but after that there is just silence. No one ca...
No it does not.Even though I can see the ap name in the controller, it gives error message "Cisco AP name is invalid." when I try "config ap reset YOURAPNAME".ThanksErcan
Hi Reza,having a static route to that network was not problem, it was the route-map settings in the config. it works fine now. NAT also works with ACL you put in your reply.ThanksErcan
