Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am using aironet 1140's in autonomous configuration to create a wireless bridge for vlan's 1, 5, 10, 15. The problem i am having is the client access point is failing to pass anything but vlan1 through to the client side network. from the client si...
ok. we have a UC500 at work on a dynamic ip that never changes. i am attempting to setup an ezvpn connection with an ASA, mainly for use with VOIP. the asa will connect, grab a vpn IP, and seem like it's connected. however, i cannot access resources ...
as the subject states, i'm trying to build a persistant VPN tunnel for data and voice. the office is static, but the satallite is my home with a PPPoE DSL broadband connection. I found a walkthrough on building a persistant VoIP VPN tunnel between 2 ...
Thank you very much. That's what i was doing wrong. I was only adding the radio sub interfaces that i thought that particular radio would be accepting clients on as well as the infrastructure ssid. I need a sub interface on every physical interface, ...
below are the interfaces configured on the 5ghz radio. if i am correct i should only need vlan1 configured since everything else is tagged. am i incorrect in my thinking? interface Dot11Radio1no ip address!encryption vlan 1 mode ciphers aes-ccm!ssid ...
i ran into this error as well. the CNA appears to be pulling a community list from the online profile somewhere as opposed to reading local config files. I am still chasing down how to prevent CNA from reloading previously deleted communities, but in...
being that i have no clue what option 150 is, probably not.a little background, i'm a linux admin/hardware tech who moved into the more mainstream of microsoft networking. i have very little actual cisco experience and this entire project to get the ...
i am using a cisco 7920 ip phone. with the tunnel connected, the phone gets a local ip (196.168.1.0) not a voice network address (10.1.1.0). even when i assign it an address on the voice network, it can't connect to the call manager.
