Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
All,I am trying to configure simple load balancing to 4 servers on a ACE (ver 3.0.0A13B), but I can't get it to work.See config below. I have L3 vlan interfaces on my Cat6513 for vlan 22, 29 and 121.Can anyone spot the issue?Thanks, Pieter-Jonprobe t...
All,I have configured an ACE with some contexts. I think I have configured it according to the documentation.If I switch to a different context using the changeto command, I switch to the context, but get the following error message:NOTE: Configurati...
Hello,We have a csm with 3 webservers.When I do a check on the connections using "sh mod csm 13 r", the csm is have around 3100 connections per real server.Checking the connections on the webserver, we see only around 1000 connections (incl. connecti...
Hi,I have the following setup:In each site I have two Cat4506's in a specific ospf area.Switch A is connected to primary data center.Switch B is connected to secondary data center.All links from the different sites to the primary- and secondary data...
Hello,We have 2 cat6513's with sup720's and csm's in FT mode.We have 3 sun webservers connected to the cat6513's using ipmp. Each server has two nic's, one nic connected to the primary switch and the other nic to the secondary switch.When I shutdown ...
Gilles,I am running a single ACE in single mode not in FT mode.However, after rebooting the ACE module, I was able to go into conf mode in all contexts.Any explanation for this behavior?Thanks for your reply, Pieter-Jon
