Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi again, Very simple 3-sites VPN setup. I cannot ping any workstations. But if i ping from the router CLI i can ping every workstation in different LAN. Can it be the ACL caused? I would greatly appreciate if anyone could help.
Hello VPN gurus,I need help here. I trying setup a 3 routers vpn. the R2 as hub. So far i can every network, but the encap,decap packets is all empy.that mean the tunnel is not established. I even do ping -t xxxx.xx.xxx and do a show crypto ipsec ...
Good day, I have a simple three routers and three-layer 2 switches. I also tried adding a layer 3 Cisco 3650 switch. I can ping every PCs that's on the layer 2 switch, but I cannot ping the PC that's on the layer 3 switch on VLAN 1. Anyone can he...
Hello all, I need help here. I just set up two routers and two layer 3 switches. Can someone check my settings? I cannot ping over to 3.3.3.1 or vice versa. I attached the PKT file. Please rename it back to PKT from PNG. I greatly greatly apprecia...
Hello all, I just started playing with the Cisco Packet Tracer.. I created a simple 3 routers and layers 3 switch with VLAN in each network respectfully. I cannot for life figure out why my VLANs computers can not even ping out to the next hop (next...
Martin, thanks for the feed back. So I found out if I don't use No Switchport. All the PC and ping other networks. hostname SW1!!!!!!ip routing!!!!!!!!!!!!!!!spanning-tree mode pvst!!!!!!interface FastEthernet0/1!interface FastEthernet0/2!interface...
