Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiWould be nice if someone could show us the light at the end of the tunnel.Got 4 Cisco Switches 2 x SG300 and 2 x SG200.All the switches are connected via fibre cable to each other.Trying to setup 2 VLAN's on the switch :1st VLAN normal network traf...
HiTrying to find a way to route between 2 firewalls with failover.2 DG ASA1(192.168.0.254) and ASA2(192.168.0.253).Currently got a HP 2910al that route all traffice to 0.254. But can't find a way to set a failover if just the internet link goes down ...
Hope someone can spread some light here please..Trying to setup PBR for traffic from one server to another to go over a direct link between site A and B.But it looks like PBR is not going over the P2P but over the VPN tunnel.Is there any way I can ch...
This helped me out with getting my config working!! Thank allot.The fix for CSCth72642 is for the Asymetric error?how do I apply this fix?Thanks again.
Hi RizwanThank you for your reply.Was not 100% sure what needs to be added to the nonat and access-lists.Got this working. But what I need to add is tunnel all traffic to the firewall where vpn is connected to so internet traffic goes via FW public i...
