Hey,In this cisco doc (http://www.cisco.com/en/US/prod/collateral/switches/ps9441/ps9670/C07-572835-00_NX-OS_vPC_DG.pdf ) I come across this statement:One of the most important forwarding rules of vPC is the fact that a frame that entered the vPC pee...
Hey,I'm getting a little consfused about what is required to get this working. I know in ucsm 2.0 isci boot is supported, and isci vnics became an option -- however does it depend which mezz card you have?For example, I see in different mezz card des...
Hey all,I'm trying to understand one thing with regards to transparent FTP proxy (via WCCPv2) and passive-mode FTP.I realize that ACNS and routers have a special service group "60", which is used for native-ftp. However their documentaion is suspicio...
Hey guys,I think I'm losing my mind here, so I need a hand.Say we have two hosts on the same isolated private vlan. There is also a promiscuous SVI for that vlan. So:Host A: 1.1.1.5/24 -- isolatedHost B: 1.1.1.200/24 -- isolatedSVI: 1.1.1.1/24 -- pro...
Hey all,This is kind of a split-horizon/poison-reverse question, but here we go.In a very simple network, lets say we have the following: A/ \B CLet's say A learns the default route 0.0.0.0/0 from both B and C, and they both have the same exact ...
Thanks Chad!Kept racking my brain on that one, and the only time it would make any sense (ie, I was trying to fit a square peg in a round hole), is if you have IGP peering to each 7K from an orphan port (ex, FW), the IGP ECMP hashes a packet to the f...
Thanks Robert.Was looking at the data sheets and couldn't find that bit of info the for palo card. Was googling a bit, but got some conflicting info -- like the Intel card on Intel's website supports iscsi boot, but from your response, it's not suppo...
Hmmm...Can you default interface f0/48 and re-configure it as a switchport? I'm tending to agree that the config didn't take. And did you try a different monitor session?(Thanks for the clarification cadetalain!)
Jon, thank you very much for helping clear this up for me. I greatly appreciate it.I failed to realize that the ACL taking action was the one on SW2. That makes perfect sense now. I thought you were referring to the ACL on SW1, which threw me for a t...
I'm pretty sure that "monitor session 1 filter vlan 51" will only work if your source ports are trunk ports. In your case they are all access ports.As for the problem, is your sniffer and/or tool in promiscuous mode?