Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Is there any document that explains the Softkeys in more detail?Beside the abbreviations it is sometimes not clear which function which softkey offers.Thanks,Daniel
Hello,I have a question regarding the RV042 and its IP-Sec capabilities.Does it support "Mode Config", an IP-Sec extension.If yes, is it documented somewhere?Regards,Daniel
Hello Daniele,There is no known issue with the power supplies of the SPA2102/WRP400.Reasons why a power supply is failing can be manifold.Brownouts, blackouts, environmental reasons.Your settings are looking ok, around the default values.And they are...
Hi Paul,It seems someone has disabled password recovery in your image (no service password-recovery).Maybe the following document will be helpful for you:http://www.cisco.com/en/US/docs/ios-xml/ios/sec_usr_cfg/configuration/12-4t/sec-no-svc-pw-recvry...
Hello Rich,You should have a similar configuration like on the attached picture (each SSID can have only 1 VLAN assigned):Go to "Wireless" -> "VLAN and QoS" and then:You enable the VLANs, choose the default VLAN ID, check "Tagged" under VLAN Tag and ...
Hello Wilgert,The MAC-address on the label correspond with the Etherport (when you connect a cable of the AP).The 2nd MAC-address, which you saw in Inssider, is related to the wireless radio in the AP itself.You can find the 2nd MAC-Address under the...
Srikanth,Because this is not anymore a question about configuration, I really would suggest you to call our hotline (Link was provided in an earlier of my posts) and get help there, if assistance with the troubleshooting is needed. Maybe you should r...
