Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need some clarity regarding IPSEC connectivity requirement for the end-points. Is it possible to use single public IP on a router and build multiple IPSEC
tunnels
from different locations/ devices using the same public IP address, or it has to be d...
I 've a router configured with multiple VRF's, I want to look for a particular subnet is lying on which VRF on the router, Is there any command to look for a particular
subnet /Prefix
onto a particular VRF on the router.
I have a layer 3 switch onto which I have created a layer 2 vlan and assigned 3 ports to this vlan, 3 PCs are connected to these ports. As per my understanding all there PC will be able to ping each other if configured with same ip...
Iam looking for some clarification regarding etherchannel, I need to add some vlans on an etherchannel allowed vlan list, 1. should this be done on the port channel configuration and not on physical interfaces as things get replic...
Hi I need help configuring QOS on cisco 3750 switch. I was previously using 2950 and that needs replaced by these 3750 and the QOS configured on the new 3750. Global configurationmls qos map cos-dscp 0 8 16 46 46 46 48 56mls qosInterface configuratio...
Thanks MHM, need further input i.e. suppose we have a router with 50 IPSEC connections, in this case is it required to have 50 unique public IPs or is it possible to bind one public IP with all 50
tunnels.
Need understand fundamentally the configurat...
I understand this however the 3 devices need to be logically segmented which I am using basically for external connectivity; two devices are router and one PC on this layer 2 subnet. I basically needed to monitor these 3 devices, could I add route o...
If I have trust qos dscp on trunk port and capture the traffic of this trunk will it has qos marking . Is qos marking on trunk while packets are entered/exit. Thanks
I have a lot consideration on 3750 but no avail. I have configured the swtich as per the configuration given above. I didn't get the desired DSCP value on packets captured on ethereal. I have qos markings on the IP Phone and port is trusting on cos w...
