About christian.schiltz

christian.schiltz · 12-20-2012

Hello,I have an CISCO 1231, I changed the IOS to put it in LWAPP mode for connnecting it to the controller.I put the IP address for the controller in: LWAPP AP CONTROLLER IP ADDRESS xxx.xxx.xxx.xxxThe LED's on the AP are alternating green, red and am...

christian.schiltz · 12-17-2012

Hello,is it possible to shut down the LED on the AP LAP1131AG?When yes, where could I find intformations how to switch it off?Thanks a lot.Best regards

christian.schiltz · 12-18-2012

But when I will change on controller, it will change on every AP? But I only want to do on one Ap, is it possible too?

christian.schiltz · 12-18-2012

I forgot an information, the AP is configured on LWAPP, so it is conected to an controller.

christian.schiltz · 12-18-2012

Hello,thanks for the great example, but I have now an other Problem on my AP.I log me in, go to the "enable" state an then I can't go to the "config" menu, why?Is there a special option that I must turn on?Thanks.

christian.schiltz · 12-17-2012

Could I do that from remote or must I connect me directly on the AP?

christian.schiltz · 12-17-2012

Yes I mean the LED which show the state of the AP.

Member Since	‎12-17-2012 06:06 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	7

User Statistics

User Activity

Problem to configure an AP CISCO 1231

Shut down LED on cisco LAP1131AG

Shut down LED on cisco LAP1131AG

Shut down LED on cisco LAP1131AG

Shut down LED on cisco LAP1131AG

Shut down LED on cisco LAP1131AG

Shut down LED on cisco LAP1131AG