Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello.I have an IOS Router with a single outbound link, terminating more than one IPSEC tunnel.I'd want some of the tunnels to be terminated on a loopback interface, and some other on the outside interface itselfCurrently, I have a single crypto map ...
Hi All.
I'm currently using a couple of WLC and Microsoft NPS to manage Wireless Network Access.
I'm successfully using AAA Override to manage to have only one SSID and dynamic vlan assignment, based on the AD Group membership, through a NPS policy ...
Hello Everybody.I'm configuring a little PBR on a Cisco 6504.
I have a VLAN with a SVI with an IP Address of 172.32.41.1 that works as the gateway for the 172.32.41.0/24 subnet
I want all the traffic from this subnet to all the 192.168.X.Y networks t...
Good Morning.Maybe my understanding of VRFs and Inter-VRF routing is still someway poor, so I apologize in advance if my question results inappropriate.
I tried to depict my very simple scenario and the simulation I tried to deploy in the attached im...
Good morning.I need help on a task involving ARP.I have a remote branch with two WAN connections:- private network to the corporate Headquarters (MPLS, VPLS)- local internet connectionThe remote branch mainly use the internet through the local access...
Sincerely, the production environment is far more complicated than what I represented here, with IPSEC tunnels and GRE tunnels going through different VRFs over an MPLS and so on... I don't know if it will be feasible to apply this "halfaway" config ...
Thank you gajownik and tvotnaI know VTI is a solution, however I'm not building from scratch.I cannot touch the rightmost routers, so I have to deal with crypto mapsNot so sure if I can have a VTI on one side (left) and a crypto map on the other sid...
Thank you for your kind reply.I'm not sure to understand your solution with a PBR.However, my problem is that because of the command "crypto map TEST local-address Loopback 2", when I apply the crypto map to the interface the address of the peer will...
I don't get the answer from 172.32.41.1 on the first line, which would be the normal intended gateway, but from 192.168.2.1.I think you are right.Great.
I still miss some things, howeverI cannot figure out why I don't have the same behaviour if I poi...
Hello richard.Sorry for the late, I had to work elsewhere, yesterday.Yes, we have some connected local networks on the 192.168.X.X prefix, as you can see.
The need is due to a company merge.The new company also has many remote sites on the 192.168.X....
