About kaysammy

kaysammy · 07-13-2016

Hello, So here's something I cannot figure out. I need to block the advertisement of only the default route 0.0.0.0/0 to neighbors on area 0.0.0.0 from Remote Site 2. If you take a look at the topology I have a main site that is used for the two re...

kaysammy · 01-26-2018

I have the same issue on the 10Gig interfaces. Also, there isn't is a massive amounts of data being pushed. Both ends are conencted at 10Gb and I see most of the transfer speed at 150Mb/s tops. The bug article doesn't seem to apply as I don't see D...

kaysammy · 07-22-2016

If i could prioritize 1 of them that would work as well. After all said and done, I need one of the routes to be preferred over the other. I figured, if I can block one of them, then the router will only have the one left to use.

kaysammy · 07-22-2016

If i get this to work like i need it to, then if the default is lost, i'll set a static route with a higher cost to go to 172.31.0.2.

kaysammy · 07-22-2016

Here's full config, before and after your route-maps, still not working as desired. main-router#sho runBuilding configuration...Current configuration : 913 bytes!version 12.4service timestamps debug datetime msecservice timestamps log datetime msecn...

kaysammy · 07-20-2016

Because all routers know about the 0.0.0.0/0 route via OSPF from each of the neighbors, if I increase the metric (already did that) on any of the firewalls, the metric changes on that firewall's (local router) neighbor and then the router uses load b...

Member Since	‎07-13-2016 12:49 PM
Date Last Visited	‎05-19-2021 02:56 AM
Posts	11

User Statistics

User Activity

OSPF block advertisement of default 0.0.0.0/0 route on backbone area

Re: Hi everyone, a document was

If i could prioritize 1 of

If i get this to work like i

Here's full config, before

Because all routers know