Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
how i can configure vtp client in switch catalyst express 520 ?.i need connect the switch catalyst express to switch catalyt 4500, will be cool automatic sharing vlans.
how can i reset to factory-default ?Cisco PIX Firewall Version 6.3(4).I try with the command "configure factory-default" ,but i receibe the next message :px01-rksl01(config)# configure factory-default'config factory-default' is not supported on PIX-5...
Configuration:- Access point 1200 series- IOS 12.3()- multiples vlan- vlan guest, without security, guest-modeFacts:Connection with HP and DELL Laptop work fine.Connection with IBM Laptop with software "IBM Access Connection" for multiple management ...
- Catalyst 4506- multiple vlans- ip route 0.0.0.0 0.0.0.0 to a pix515 for internet traffic controlissue : an linksys router with independent internet access was connected, for some reason the catalyst 4506 now send the trafic for the linksys"sh ip ...
for all the interested onesok, unfortunately at this moment the problem no longer exists, i do not understand, i try to reproduce the problem but it was not possibleat the moment of the problem, the traceroute in the 4506 shows clearly how the traffi...
the MAC address from the Linksys and PIX515 is not the same in arp table in the 4506ping from internet is supply from LinksysThis is the test:pix515 10.0.1.211Linksys 10.0.0.74cat4506#cat4506#ping 200.23.18.254Type escape sequence to abort.Sending 5,...
