Hi All,I'm new to Cisco UCS and don't fully understand it's compatibility with non-Cisco gear. My questions are primarily driven around the concept that Cisco UCS smartplays appear to be significantly cheaper than the traditional configurations that ...

Hi All,I'm trying to test 802.1x authentication in a lab environment with some standalone 1131AGs and a Server 2008 R2 NPS server. I've been able to set up a few different scenarios but none have met all my requirements:Scenario 1:Laptops in the doma...

Hi everyone,I have two CIsco 5510s in an active/passive configuration running 8.3. I have a local DHCP pool and use radius authentication to authenticate/authorize VPN clients. On average I have 30 active client VPN connections along with 1 site to s...

Hello,I have two Internet circuits that I want to connect to the ASA. Prior to 8.2 I've been able to configure dynamic NAT for both interfaces and add two routes so that if one circuit went down outbound traffic would flow out of the second circuit. ...

We have a potential project spanning two sites a few miles apart. We are hoping of putting 1 controller at each site in a single mobility group to provide AP failover if one controller is to fail. We are planning on a total of 25-30 APs, roughly half...