Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,At the beginning, our client network was composed by a lot of C2811 Cisco router.We used a Plink command (with Putty) from our management console to connect on C2811 and launch some CLI commands.The plink SSv2 command was :plink -ssh -use_vintela_...
Hi,I'm working on a network architecture as presented below :PC1 -- Router 1 configured as Bridge -- Router 2 -- PC2My Router 1 need to be configured as a bridge (the bridge is done between gi0/0 and gi0/1 by using a BVI interface).Router 1 is 3825 w...
Hi All,Here below you can find my problem:- I have a network with one WAE Manager and 8 WAE Client that are correct registered on my WAE Manager.- I also have a server that collect snmp traps- I configured all my WAE and they send correctly the confi...
Hi,The ouptut of plink is : "FATAL ERROR: Incoming packet was garbled on decryption"I have only two 2911 with the same IOS.Other routers are 2811 routers and all is ok with 2811Yes, the problem appears only on 2911I can make a SSHv2 connection manual...
